Installation and Maintenance





Installation instructions for turning design toilet brush


1.  Review the enclosed material connection to its completeness
     (2 stud screws, two plugs 8mm). The remaining parts are replacement parts that you should keep safe.

2.  Drill a hole at the desired height (Ø 8mm), about 5cm deep. And you put one of the enclosed dowel.

3.  Take the bottom of the toilet brush pot and turn the screw with the stock M8 threaded into it (that part of the
      screw), until the last thread is no longer visible.

4.  Now turn the other end of the stick screw into the dowel into it. If you notice the floor, the bolt is stuck firmly
     adjust the Haltetopf, so it shows the top.

5.  Now place the top of the Haltetopfes in the lower.

Many congratulations they have now successfully installed its rotating design toilet brush.
If you have questions you can reach us at:


Drehdesign Vertriebsgesellschaft UG

Wolfgang Peter

In Klinkenthal 25

66 578 Schiffweiler

Tel: 06821/962-004

Fax: 06821/962-005

@-Mail: [email protected]



Care instructions for all of our coatings:


To clean our surfaces and / or maintain a neutral detergent We would recommend the you use. In order to remove minor contamination, clean the surface with a little soap, a damp cloth and dry it afterwards with a soft cloth (we recommend a Cotton cloth!).

The coatings should under no circumstances with detergent in contact which hydrochloric acid, formic acid, acetic acid, phosphorus, or mix any substances included!

The use of aggressive abrasives, abrasive sponges and Reinigungswolle should be avoided at all costs.

Failure to follow these care instructions Drehdesign takes no guarantee!

Back